Winterizing Power Sports Equipment

Filed in Maintenance, On The Lake by on September 10, 2016

Young Man and girl on Jet Ski, jetski in Ukraine

By Dave Pedersen

There is more to maintaining a boat or personal water craft besides the motor. Marine vehicles should be protected inside and out, especially in cold climates, fully protecting your valuable recreational asset. Winterizing is an important step in maintaining your water craft.
You can winterize your power sports equipment by taking it to a local marine service center or you can do it yourself.
You should remember that your insurance policy may not cover damage done by lack of maintenance or neglect.
If you decide to do it yourself, the checklist should include:
  • Change the oil and oil filters.
  • Change the lubricant in engine transmission or the outboard lower unit.
  • Apply fogging, if called for by manufacturer.
  • Drain the boat’s fuel tanks as much as possible.
  • Fill the boat’s fuel tanks completely full.
  • Add biocide and/or stabilizing agents to fuel.
  • Change the fuel filters.
  • Add antifreeze to the engine’s cooling system.
  • Add distilled water to batteries, charge completely and disconnect.
Before you begin, plan ahead by gathering all the necessary items to perform the task. Add to the checklist tasks or specific products recommended by the manufacturer’s manual.
There are good reasons for why all this maintenance is necessary. After running your boat all summer, it is likely that water, acids and other byproducts have built up. It’s important to change the oil to prevent corrosion and excessive wear which can lead to loss of power, poor fuel economy or engine failure.
Fresh water expands in volume by about nine percent when it freezes and can push out wards with a force of tens of thousands of pounds per square inch. That expansion can crack an engine block, damage fiberglass, split hoses or destroy a refrigeration system.

An analysis of 10 years of freeze claims from the BoatUS Marine Insurance claim files found that more than three-quarters involved cracks in the engine block or the exhaust manifolds that occurred because water remained in the engine or cooling system during a hard freeze.

A customer came in last spring saying his new inboard boat won’t run right, said Tyler Neumann, service manager at Frontier Power Sports in Fergus Falls. “It turned out the engine was cracked because he said he did not know to winterize it. It cost him about $10,000.”
Repairing freeze damage takes time and all too often involves a complete engine replacement.
In The Boater’s Guide to Winterizing, you’ll find the list of items that would have prevented more than 95 percent of the freeze claims handled by the BoatUS Marine Insurance Program in the past decade.
To protect the engine against damage from freezing, run antifreeze through the engine. For the best protection use marine engine grade antifreeze, either one rated to -60 or -100 degrees. Do not dilute the antifreeze or it will not perform correctly.
To protect the inside of the engine until spring you must fog the engine to protect its moving parts. You can spray them into the carburetor while the engine is running or apply it through spark plugs holes while the engine is turned over.
Winterization starts with prepping the fuel supply long before the day you haul out for the winter. The engine’s fuel supply should be treated for storage during the last week or so of your boat’s in-water use. Neumann says they used to tell customers to fill the gas tank and add a stabilizer. However, he adds that ethanol in today’s gas is not good for boats at all. It breaks down the gas and gums up the engine in a short time. Now he tells customers to drain the tank as empty as possible and stabilize the rest. If a tank is empty there is no need for a stabilizer.
If your boat is small enough, simply disconnect the batteries and bring them home. Add distilled water and charge them occasionally.
For larger boats, disconnect the batteries, add distilled water and then periodically reconnect and charge them using shore power.
There is a benefit in removing batteries and storing them in a warm environment. The cold saps the juice out of batteries, providing less cranking capacity. The other benefit is that the cable connections get cleaned when the battery gets put back.

To double the life of a battery, there is a charger, called a battery tender, available that you can leave on the battery all winter. It will not overcharge the battery, sensing the level of charge, only working as needed.

The old chargers would overcharge and ruin the battery if left on all winter. Plus, batteries have gone way up in price, so it makes sense to keep yours maintained properly.
Winterize the hull and interior of the boat. First, do a thorough examination of the hull, keeping a careful lookout for blisters in the gelcoat.
Also check for stress cracks which most often occur near the bow. Finally, pressure-wash the hull to remove dirt and debris.
Fall/winter is a perfect time to put the shine to your boat’s gelcoat, restoring or maintaining your boat’s shiny finish. By washing and waxing the boat before it goes into storage you will have less work to do when spring arrives.
Storing your boat outdoors in shrink-wrap or indoors each has their own advantages and disadvantages. If you store your boat outdoors, be sure to choose a sturdy boat cover and support structure to withstand heavy snow.
If you want to keep mice from causing trouble keep your boat away from buildings, including indoor storage areas. Neumann adds he has tried everything to keep them out but nothing seems to stop them, even mouse poison or shrink wrap.
The work you do at the end of the boating season will extend the life of your craft and is well worth the time (and money) to do it right.

Tags: , ,